You could but you may run into ground loops. The better the source, the better the outcome! Can I split the signal from the ProRMP to drive more than one amp? Most folks generally prefer an active direct box like the Radial J48 or Pro48 for re-amping as this delivers a good clean signal to the recorder. This is truly a matter of taste and budget.
What is the best DI to use when re-amping? The JDI will likely saturate due to the much finer wire needed to effectively do the job. The ProRMP is optimized for recording while the JDI is optimized to work the other way round as a direct box. The ProRMP’s transformer is designed to accept a +4dB balanced line-level input from a recording system while a direct box is designed to accept a very low -50dB signal from an instrument. What is the difference between using a Radial JDI backwards for Reamping versus using the ProRMP? Because the ProRMP is produced in larger quantities, it is more affordable. Both work very well and are often compared. The Reamp JCR employs the original John Cuniberti designed transformer with an ultra low noise eliminating MuMETAL® shell. The difference lies in the quality of the transformer. What is the difference between the Radial ProRMP the new Reamp™ JCR?īoth units are similar in that they are both passive. The benefit to a passive Reamper like the ProRMP is that it does not require any power and it costs less.
The benefit to having the active buffer is that you can drive more than one amp at the same time and adjust the level with less effect on the tone. This means that the ProRMP employs a transformer while the X-Amp employs an active buffer or internal amplifier to drive the signal. The ProRMP is passive while the X-Amp is active. What is the difference between the Radial ProRMP and the Radial X-Amp?
#Radial engineering jcr free
If you don't see the question you had in mind here, feel free to enter in the form provided along with your email address so we may send the reply directly to you.
0 kommentar(er)
